User manual

AN-80i User Manual
70-00072-01-10 Proprietary Redline Communications © 2011 Page 101 of 152 March 2, 2011
Table 33: CLI - show (PMP-Specific Commands)
98 Data B Conn Enabled
99 Voice B Conn Enabled
100 Data C Conn Enabled
101 Voice C Conn Enabled
links
Display information for all
Links.
192.168.25.2(show)# links
4 Sub A Link Down
5 Sub B Link Down
10 Sub C Link Down
15 Sub D Link Down
6.1.19 Snmpcommunity
Use the snmpcommunity command to configure SNMP community permissions.
Table 34: CLI - snmpcommunity
Configure SNMP community permissions.
snmpcommunity <add> <clearall> <default> <del> <print>
add <name> <rights>
Add a new SNMP community to the SNMP community table. The index value is assigned
automatically. Up to eight community entries can be entered.
name
Enter the SNMP community name.
rights
Specify the rights for this community string. Where.
0: Deny read and write permission (enter zero).
r: Grant read access permission only.
w: Grant write access permission only.
rw: Grant read and write access permission.
clearall (no parameters)
Delete all SNMP parameters.
default <idx>
Set all SNMP parameters to factory default settings.
idx Specify single entry to be set to default (use 'print' command to display ids).
del <idx>
Delete the specified community entry.
idx Specify single entry to be deleted (use 'print' command to display ids).
print
List all SNMP communities and associated permissions.
6.1.20 Snmptrap
Use the snmptrap command to configure the SNMP trap message reporting.
Table 35: CLI - snmptrap
Configure SNMP community trap settings.
snmptrap <add> <change> <clearall> <del> <print>
add <ipaddr> <port> <identity>
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]