User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 96 of 128 June 4, 2009
5.2.20 Snmptrap
Use the snmptrap command to configure the SNMP trap message reporting.
Table 33: CLI - snmptrap
PTP PMP Description
√ √
Configure SNMP community trap settings.
snmptrap <add> <change> <del> <print>
add: Add a new SNMP trap. The index value is assigned
automatically. Up to eight settings can be entered.
snmptrap add <ipaddr> <port> <community> <Enter>
change: Modify the specified SNMP setting.
snmptrap change <idx> [-p <port>] [-i <ip_add>] [-c
<community] <Ent>
del: Delete the specified SNMP setting.
snmptrap del <idx> <Enter>
print: List all SNMP trap settings.
snmptrap print <Enter>
5.2.21 Test
Use the test command to load the current edited (but not permanently saved)
configuration settings. The AN-80i will operate with these settings for a period of five
minutes. During the 'test' period, you may click the Save button at any time to save this
configuration permanently (also terminating the five minute timer). If the Save button is
not
selected, the previous saved settings are reloaded.
Table 34: CLI - test
PTP PMP Parameter/Description
√ √ Load the current edited configuration settings (for five minutes).
test <config>
Test AN-80i configuration settings
config - Load and test configuration settings
5.2.22 Upgrade
Use the upgrade command to upload a new software binary file to the AN-80i.
Table 35: CLI - upgrade
PTP PMP Description
√ √ Configure SNMP community permissions.
upgrade <ipaddr> <filename> <username> <password>
ipaddr: Enter the IP address of the TFTP server.
filename: Enter the name of the binary file to be uploaded.
username: Enter FTP account name (FTP server only).
password: Enter FTP account password (FTP server only).