User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 95 of 128 June 4, 2009
Table 31: CLI - show
PTP PMP Description
25 Conn Not Enabled
26 Sub001 Link Enabled
27 SS01-Data Conn Enabled
28 SS01-Voice Conn Enabled
links
Display information for all links.
log
Display the system log.
snmp
Display the SNMP configuration.
stats
Display all statistics.
* Status codes are displayed in binary format. See section 6.5: Status Codes on
page 105 for details of the RF status codes.
5.2.19 Snmpcommunity
Use the snmpcommunity command to configure SNMP community permissions.
Table 32: CLI - snmpcommunity
PTP PMP Description
√ √
Configure SNMP community permissions.
snmpcommunity <add> <default> <del> <print>
add: add a new snmp community to the snmp community
table. The index value is assigned automatically.
Up to eight community entries can be entered in
the table.
snmpcommunity add <name> <string> <Enter>
snmpcommunity add <rights> 0 | r | w | rw <Enter>
Where.
0 (zero):Deny read and write permission.
r: Grant read access permission only. Deny write permission.
w: Grant write access permission only. Deny read permission.
rw: Grant read and write access permission for this community.
default: Set all snmp parameters to factory default
settings.
snmpcommunity default <idx> <Enter>
del: Delete the specified community entry.
snmpcommunity del <idx> <Enter>
print: List all SNMP communities and associated
permissions.
snmpcommunity print <Enter>