User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 92 of 128 June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
Enter the IP netmask.
optionskey <kidx> <kStr>
Enter the options key string.
kIdx - Index of the options key [0 | 1]
kStr - [<options_key_string]
peermac <value>
Enter the MAC address of the communicating AN-80i. Required
for wireless encryption.
radio <on | off>
Enable or disable the radio transmitter.
off - Disable
on - Enable
regper <value>
The number of frames between registrations [4..100].
rffreq <value>
Enter the center frequency for the RF channel. When operating
multiple links in close proximity, channel frequencies should be
separated by a minimum of the channel size to minimize
interference. For example, when operating in with 20 MHz
channels, the separation must be greater than 20 MHz.
snmp <on | off>
SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.
snmptraplink <on | off>
Enable or disable sending an SNMP trap message for
each link-up and link-down event.
off - Disable the SNMP trap message.
on - Enable the SNMP trap message.
snmptraps <on | off>
Enable or disable sending all SNMP traps.
off - Disable all SNMP trap messages.
on - Enable all SNMP trap messages.
sntp <on | off>
SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
sntpip <value>
Enter the SNTP server IP address. Valid only if sntp is enabled.
sntppoll <value>
Enter the SNTP polling interval in hours.
sstoss <id> <mode>
Status of packet routing between SSs.
id - [id number]
mode - Route broadcast packets from SS to SS
off - Disable routing.
on - Enable routing.
syscontact <value>