User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 91 of 128 June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
Group rate.
id - [id number]
rate - group rate
grpvid <id> <vid>
Group VLAN ID.
id - [id number]
vid - VLAN ID
grpviden <id> <mode>
Group VLAN enable.
id - [id number]
mode-
on -Enabled
off - Disabled
http <on | off>
Enable or disable the HTTP function. When disabled, the Web
interface will not be available.
off - Disable
on - Enable
https <on | off>
Enable or disable the HTTPS function.
off - Disable
on - Enable
idname <id> <name>
ID and name.
id - [id number]
name - id name - maximum 15 characters
ipaddr <address> <mask>
Enter the IP address and subnet mask of the AN-80i.
Confirmation is required.
Address - IP Address
Mask - Subnet Mask
Yes - Confirmation to proceed
maxdst <value>
Maximum distance to a subscriber [Km].
maxtxpower <value>
Enter the Tx power level (dBm). This setting is for the
transceiver output only. The actual EIRP depends on the gain
of the connected antenna. See section 8: Appendices for a list
the maximum transmit power setting based on the antenna gain
for a series of frequency settings. The maximum value for this
field is determined by the options key.
mgmtag <on | off>
Enable or disable the HTTPS function. See also mgmvid.
off - Do not used VLAN to identify management traffic.
on - Enable VLAN tagged management traffic. See mgmvid.
mgmvid <vlan_id>
Specify Management VLAN ID. See also mgmtag.
vlan_id - Management VLAN ID.
netmask <netmask>