User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 90 of 128 June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
Connection priority.
id - [id number]
pri - VLAN priority
convid <id> <vid>
Connection VLAN ID.
id - [id number]
vid - VLAN ID
conviden <id> <mode: on | off>
Connection VLAN enable.
id - [id number]
mode
on - Enabled
off - Disabled
dlqos <id> <gos>
Downlink QoS.
id - [id number]
qos - QoS
dlrate <id> <rate>
Downlink rate.
id - [id number]
rate - rate
ethmode <auto | 10hd | 10fd | 100 fd | 100hd>
Enter a value for the combined Ethernet speed and duplex.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
100hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
exit
Exit from the current mode (go up one level).
flowctrl <on | off>
Enable or disable the flow control function. The Flow control
feature enables the AN-80i to request other Ethernet devices to
pause transmission during busy periods.
off - Disable
on - Enable
gateway <IP address>
Enter the IP address of the default gateway on this segment.
gmt <value>
Enter the time offset from GMT (e.g., -5 for EST).
grppri <id> <pri>
Group priority.
id - [id number]
pri - VLAN priority
grpqos <id> <gos>
Group QoS.
id - [id number]
qos - QoS
grprate <id> <lrate