User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 88 of 128 June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
Enable or disable sending an SNMP trap message for
each link-up and link-down event.
off - Disable the SNMP trap message.
on - Enable the SNMP trap message.
snmptraps <on | off>
Enable or disable sending all SNMP traps.
off - Disable all SNMP trap messages.
on - Enable all SNMP trap messages.
sntp <on | off>
SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
sntpip <value>
Enter the SNTP server IP address. Valid only if sntp is enabled.
sntppoll <value>
Enter the SNTP polling interval in hours.
ssh <on | off>
Enable or disable the SSH function.
off - Disable
on - Enable
syscontact <value>
Enter additional descriptive details about this AN-80i. The
description can be any combination of up to 20 letters and
numbers.
sysdescr <value>
Enter descriptive details about this AN-80i. The description can
be any combination of up to 20 letters and numbers.
sysloc <value>
Enter descriptive details about the location of this AN-80i. The
description can be any combination of up to 20 letters and
numbers.
syslog <on | off>
Syslog enable setting.
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
syslogip <value>
Enter the syslog server IP address. Valid only if syslog is
enabled.
sysmode <ptpsmaster> <ptpslave>
ptpsmaster - The sector controller (base station) begins
transmitting automatically; sending poll messages to locate the
remote subscribers (ptpslave).
ptpslave - Subscriber waits passively, monitoring the selected
channel(s) until polled by the ptpmaster (base station).
sysname <value>
Enter the name for this AN-80i. The name can be any
combination of up to 20 letters and numbers.
telnet <on | off>
Enable or disable the Telnet
p
ort. If the Telnet
p
ort is disabled,