User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 86 of 128 June 4, 2009
Table 30: CLI - set
PTP PMP Parameter/Description
encmode <0 - 4>
Enable or disable the encryption function.
0 - Disable
1 - 64-bit (Redline)
2 - AES 128
3 - AES 192
4 - AES 256
Important: If encryption is enabled, the same encryption level
must be selected on both communicating systems.
ethmode <auto | 10hd | 10fd | 100 fd | 100hd>
Enter a value for the combined Ethernet speed and duplex.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
100hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
exit
Exit from the current mode (go up one level).
flowctrl <on | off>
Enable or disable the flow control function. The Flow control
feature enables the AN-80i to request other Ethernet devices to
pause transmission during busy periods.
off - Disable
on - Enable
gateway <IP address>
Enter the IP address of the default gateway on this segment.
gmt <value>
Enter the time offset from GMT (e.g., -5 for EST).
http <on | off>
Enable or disable the HTTP function. When disabled, the Web
interface will not be available.
off - Disable
on - Enable
https <on | off>
Enable or disable the HTTPS function.
off - Disable
on - Enable
ipaddr <address> <mask>
Enter the IP address and subnet mask of the AN-80i.
Confirmation is required.
Address- IP Address
Mask - Subnet Mask
Yes - Confirmation to proceed
lkname <value>
Enter the name of the remote unit (maximum 15 characters).
maxtxpower <value>
Enter the Tx power level (dBm). This setting is for the
transceiver output only. The actual EIRP depends on the gain
of the connected antenna. See section 8: Appendices for a list