User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 82 of 128 June 4, 2009
Table 22: CLI - load
√ Load PMP values from a remote TFTP server.
load <idtable> <script>
idtable Load all IDs from flash memory.
script <server> <name>
Use the script command to load configuration file (see script)
The file must be located in the TFTP default directory.
server Server IP address
name Script file name
5.2.10 Logout
Use the logout command to terminate the current Telnet session.
Table 23: CLI - logout
PTP PMP Parameter/Description
√ √ Terminate the current Telnet session.
logout [no parameters]
5.2.11 New
Use the new command to create a new link, group, or connector ID.
Table 24: CLI - new
PTP PMP Parameter/Description
√ Create a new link, group, or connector ID.
new <id_type> <id>
id_type - Specify the link type:
link - Link
group - Group
conn - Connection
id - Specify the ID number for this link/group/connection.
5.2.12 Ping
Use the ping command to initiate an ICMP ping command from the AN-80i.
Table 25: CLI - ping
PTP PMP Parameter/Description
√ Send an ICMP ping command.
ping <address> <count>
address Target IP address
count Number of ICMP packets to send (1 to 16).
5.2.13 Reboot
Use the reboot command to reboot the AN-80i.
Table 26: CLI - reboot
PTP PMP Parameter/Description
√ √ Command the AN-80i to reboot. Zero cancels reboot in-progress.
reboot <seconds>
seconds - Time to wait in seconds.