User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 78 of 128 June 4, 2009
5.2.5 Enable
Use the enable command to re-enable a specific ID (that was disabled).
Table 18: CLI - enable
PTP PMP Parameter/Description
√ re-enable a specific ID (that was disabled).
enable <id>
id - [id number]
5.2.6 Freq
Use the freq command to configure frequency ranges when using autoscan or DFS.
Table 19: CLI - freq
PTP PMP Parameter/Description
√
freq <add> <del> <print> <reload>
add Add a frequency range (up to 32 ranges).
<begin> - start frequency (MHz)
<end> - end frequency (MHz)
del Delete a frequency validation range
<index> - Frequency validation range index
print Print the list of frequency validation ranges.
Local frequency ranges:
<index> <begin> <end>
reload Reload the active list of frequency validation ranges.
5.2.7 Generate
Use the generate command to generate a DSA or RSA key for use with SSH.
Table 20: CLI - generate
PTP PMP Parameter/Description
√ Create keys of the specified type. The keys are saved in flash and
runtime memory.
generate <sshkey>
sshkey <type>
type Key type can be dsa or rsa.
5.2.8 Get
Use the get command to view system parameters. Use the following general format to
view a parameter:
get [field] <Enter>
Table 21: CLI - get
PTP PMP Parameter/Description
√ Display PTP parameters.
get <parameter>