User manual

& User

AN-80i

Manual

5.2 CLI Command Set

5.2.1 Arp

Use the arp command to manually add static ARP definitions to the AN-80i ARP table

(e.g., for wireless link aggragation). A maximum of two static (persistent) entries can be

added to the table. Use the 'save config' command to permanently save changes to the

static entries in the ARP table. Static entries loaded at boot time are recorded in the AN-

80i system log.

Table 14: CLI - arp

PTP PMP Parameter/Description

√

arp <add> <del> <print>

add Add a new static entry in the AN-80i ARP table. Use 'save config' to

save these entries permanently. A maximum of two static entries

can be added to the table.

<IP> Host IP address. Must be same subnet as AN-80i unit.

<MAC> Host MAC address (e.g., 01-02-03-04-05-06)

del Delete a static or dynamic entry from the ARP table.

Also see 'clear arptable' command.

<IP> Host IP address of ARP entry to be deleted

print Print the ARP table. The * indicates manually entered values.

For example:

192.168.25.12# arp print

192.168.25.1 at 00:05:5d:e0:5b:10

192.168.25.22 at 11:22:33:44:55:66 *

192.168.25.33 at 01:02:03:04:05:06 *

192.168.25.201 at 00:05:5d:e0:5b:10

Persistent MACs:

192.168.25.22 at 11:22:33:44:55:66

192.168.25.33 at 01:02:03:04:05:06

5.2.2 Chgver

Use the chgver command to change the software version loaded when the AN-80i is

rebooted.

Table 15: CLI - chgver

PTP PMP Parameter/Description

√ √ Enter this command to toggle between software versions. The setting

will alternate between the two banks of memory (no parameters).

chgver [no parameters]