User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 59 of 128 June 4, 2009
Wireless Interface
Use settings on this section of the screen to configure the AN-80i wireless interface.
Figure 33: Web - PMP - Wireless Settings
The following fields are specific to operation in PMP mode. Refer to 3.6.2: SNMP
Settings Screen on page 33 for information on all other fields.
System Mode: The system designated as sector controller establishes and manages
the bi-directional data link with a remote end AN-80i. Only one system in a wireless link
must be set for Sector Controller mode (PMP SC).
PMP SC: AN-80i begins transmitting automatically, sends poll messages to locate
remote AN-80i subscribers, and negotiates operating settings for the link.
PMP SS: AN-80i waits passively, monitoring the selected channel(s) until polled by
the PTP Sector Controller.
Registration Period: The polling period for detecting new subscribers. Period is based
on the number of wireless frames transmitted. Permitted values are 1 to 400 frames. It is
recommended to use 4 frames as the default registration period.
Max. Distance [km]: Enter the distance to the subscriber located farthest away from the
sector controller (outer boundary of sector). This parameter is used to optimize
communications with the subscribers.