User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 54 of 128 June 4, 2009
5. Enter the pass through Group ID in the Parent Group ID field. Click the Groups
List text to select from the list of groups created in step II.
6. Set the downlink and uplink UBR rates in the DL QoS Level and UL QoS Level
fields. It is recommended to use the values Max. DL Burst Rate - 1 and Max. UL
Burst Rate - 1.
7. Click Apply to save and activate this connection.
Repeat steps 1 - 7 to add additional connections.
Step IV: Save Configuration
Click Save in the left-hand menu to permanently save all settings. The system is now
configured to pass all traffic (tagged and untagged data). Use this configuration to verify
connectivity to system components over the wireless interface.
Important: It is recommended to use Redline's PMP Configuration Tool to obtain
accurate QoS values for all Groups and Connections. UBR settings must be based on
the link budget.
Configure VLAN Tagging
Use these steps to change from pass-through to VLAN tagged connections.
Step I: Change Group to Tagged
1. Click New Group to add a group definition.
2. Enter a unique name for this group in the Group Name field.
3. Select Tagged in the Group tagging mode field.
4. Enter the VID (for sector controller local network) for this group in the Group VLAN
ID field.
5. Check the SC Ethernet Enable box .
6. Enter the value 5 for the Group QoS Level.
7. Click Apply to save and activate the group settings.
Repeat steps 1 - 7 to create new VLAN groups as required.
Step II: Change Connections to Tagged
1. Click Links to display the Links Browse screen.
2. Locate a Link to be changed to VLAN Tagged type and click Expand to view the
Browse Connections screen.
3. Choose the Connection to use VLAN tagged traffic and click Config to edit the
settings.
4. Select Tagged in the Connection tagging mode field.
5. Enter the VID (for subscriber local network) in the Connection VLAN ID field.
6. Click the Groups List text and select the Group created for this VLAN (Parent
Group ID).
7. Click Apply to save and activate these changes.
Repeat steps 1 - 7 to configure each connection requiring VLAN.
Step III: Save Configuration
Click Save in the left-hand menu to permanently save and activate all settings.