User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 25 of 128 June 4, 2009
PTP Master: An-80i transmits automatically; sending poll messages to the remote
AN-80i and negotiating the UBR (modulation and coding) for the wireless link.
PTP Slave: This unit waits passively until polled by the PTP Master.
RF Channel Frequency: Current RF channel frequency.
Tx Power: The current transmit power level. If ATPC is enabled, this value may be
different than the Tx Power setting in the System
Configuration screen.
DFS Enabled: Indicate the status of the DFS feature. Refer to 3.6.3 Wireless
Configuration for a complete description of the DFS feature.
Enabled: The DFS feature is activated. See
DFS Action below.
Disabled: The DFS feature is disabled.
DFS Action: Indicates the DFS action to be taken by the AN-80i equipment. Refer to
3.6.3 Wireless Configuration for a complete description of the DFS feature. All DFS
actions are recorded in the event log.
None: The DFS feature is disabled.
Tx Off: Transmitter was switched off for 30 minutes.
Chg Freq: Transmitter was switched to a different frequency.
Link Distance: Distance between wireless systems. This may be the calculated or user-
assigned distance (System Configuration screen).
Status Code: Code indicating the condition of the AN-80i system. Status indications are
specific for PMP and PTP operation.
Ethernet MAC Address: System hardware address (also printed on product label).
IP Address: User-assigned IP address of the AN-80i.
IP Subnet Mask: User-assigned IP subnet mask.
Default Gateway Address: User-assigned IP for the default router or gateway.
3.4.2 Ethernet LAN Statistics
Rx Packets: Total packets received on the Ethernet port.
Rx Packets: Discarded: Total valid Ethernet frames received on the Ethernet port that
are discarded due to lack of buffer space.
Tx Packets: Number of packets transmitted on the Ethernet port (including Ethernet frames
and error correction bytes).
3.4.3 Wireless Statistics
Link ID: A new session identifier each time the wireless link is established.
Received Signal Strength: Min: Minimum measured RSSI value.
Received Signal Strength: Mean: Average measured RSSI value.
Received Signal Strength: Max: Maximum measured RSSI value.
SINADR: Ave. signal to interference, noise, and distortion ratio (updated each refresh).
Rx Packets: Total number of packets received over the wireless interface.
Rx Packets: Retransmitted Number of packets received over the wireless interface
retransmitted by the remote-end system (ARQ retransmit of unacknowledged packets).
Rx Packets - Discarded: Number of received packets discarded due to errors.
Tx Packets: Number of packets transmitted over the wireless interface.
Tx Packets - Retransmitted: Number of packets re-transmitted over the wireless interface
(ARQ mechanism re-transmitting unacknowledged packets).