User manual

& User

AN-80i

Manual

3.3 System Information Screen

Click General Information to view the system overview screen (read-only). Refer to the

System

Configuration screen for information about changing these settings.

3.3.1 Dashboard

The dashboard at the top of the General Information screen displays a summary of

important operational information and status indicators.

Figure 8: Web - PTP Dashboard Display

General

IP Address: IP address setting of this unit.

Wireless Frequency: RF channel frequency.

Time: Displays time obtained from operator's Web browser.

RSSI: Received signal strength indicator measured since the last screen refresh.

SINADR: Average signal to interference, noise, and distortion ratio.

Radio Temperature: Internal temperature of the radio.

Wireless Led Indicators

When data sent over the wireless interface is being encrypted, a key symbol is displayed

adjacent to the 'Wireless' title in the dashboard. Refer to the Wireless Security

Configuration on the System Configuration screen.

Figure 9: Web - PTP - Dashboard Display - Wireless Key Symbol

Wireless Data Link LED: Lights solid green when data can be transmitted across the

wireless interface (LED is valid only when the RF Link LED is lit).

Wireless RF Link LED: Lights solid green when the wireless link is established.

Wireless Signal LED: Lights when a wireless link is established. Signal indications are

based on the Adaptive Modulation setting:

Enabled: Lights solid green when wireless link is operating at the rate equal to the

Uncoded Burst Rate setting, and blinks when operating at a lower rate.

Disabled: Lights solid green when the wireless link is established.

Ethernet LED Indicators

Ethernet Link LED: Lights solid green when there is an Ethernet connection and no

traffic, and blinks when traffic is detected.

Ethernet 100 LED: Lights solid green when the Ethernet port is operating at 100 Mb/s

and is off when operating at 10 Mb/s.

Ethernet FD LED: Lights solid green when the Ethernet connection is operating in full

duplex mode and blinks when collisions are detected on the Ethernet port.