User manual

& User
AN-80i
Manual
70-00072-01-08b Proprietary Redline Communications © 2009 Page 120 of 128 June 4, 2009
8.4.2 5.4 GHz Radio: FCC & IC Antennas
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 22 dBi.
Table 65: Spec. - FCC & IC Certified Antennas: 5.47-5.725 GHz Operation
Redline Order # Gain
(dBi)
Description Tx Power
Setting (dBm)
(Part Number) 10 MHz 20 MHz 40 MHz
A36009MMO
(48-00048-01)
9 360°, 5.0 - 6.0 GHz, omni directional
7 7 7
A12015EAS
(48-00065-00)
15 120°, 4.9-5.9 GHz, sector flat panel
7 7 7
A9016EAS
(48-00066-00)
16.6 90°, 4.9-5.9 GHz, sector flat panel
7 7 7
A6017EAS
(48-00067-00)
17.5 62°, 4.9-5.9 GHz, sector flat panel
7 7 7
A2209MTFW
(48-00071-00)
22 9°, 4.9-5.875 GHz, sector, flat panel
7 7 7
Antennas not included in this list or having a gain greater than 22 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms. The RF
output power and selection must be professionally programmed and the equipment must
be installed by the manufacturer or a trained professional installer.
8.4.3 5.25 - 5.35 GHz Radio: FCC & IC Antennas
This device has been designed to operate with the antennas listed below, and having a
maximum gain of 22 dBi.
Table 66: Spec. - FCC & IC Antennas: 5.25 - 5.35 GHz Operation
Tx Power Setting (dBm)
Channel Size
Redline Order #
(Part Number)
Gain
(dBi)
Description App.
10 MHz 20 MHz 40 MHz
A36009MMO
(48-00048-01)
9 360°, 5.0 - 6.0 GHz, omni
directional
PMP 10 12 13
A12015EAS
(48-00065-00)
15 120 deg., .9-5.9 GHz,
sector flat panel
PMP 10 12 13
A9016EAS
(48-00066-00)
16.6 90 deg., 4.9-5.9 GHz,
sector flat panel
PMP 10 12 13
A6017EAS
(48-00067-00)
17.5 62 deg., 4.9-5.9 GHz,
sector flat panel
PMP 10 12 12
A2209MTFW
(48-00071-00)
22 9°, 4.9-5.875 GHz, sector, flat
panel
PTP 7 7 7
* FCC regulations require the DFS function be permanently enabled at the factory and can not be disabled
by the installer/end-user when operating in the 5.25-5.35 GHz range.
Antennas not included in this list or having a gain greater than 22 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms. The RF
output power and selection must be professionally programmed and the equipment must
be installed by the manufacturer or a trained professional installer.