Instruction manual

REDLAKE MASD, INC.
_____________________________________________________________________________
9400-0024 Rev G II 05/15/01
APPENDIX B PERFORMANCE SPECIFICATIONS
Image Resolution: 292 x 220 pixels per frame. 60 thru 500 fps. 292 x 110 pixels on
a half-height frame at 1000 fps.
Lens Mount: Standard C-Mount lens.
Record Rates: (50 PAL, 60 NTSC), 125, 250, 500 and 1000 fps.
Shutter Speed: Electronic shutter operates at rates of 1X to 20X of record rates.
Exposure time ranges from 1/60th sec. to 1/20,000th sec.
Live/Setup Mode: The camera comes up in Live mode at power on. The camera
returns to Live mode when record or playback is terminated.
Record Mode: Records when you press red button:
Continues to store images in the memory until you press:
Stops recording so that all frames precede the frame
active when the button was pressed.
Trigger: When the Trigger signal stops recording, the camera may
continue to store images to the end of the buffer, depending on
the Trigger Point setting.
Frame Storage:
Standard Capacity: 1,024 frames (2,048 at 1000fps).
Enhanced Capacity: 2,048 frames (4,096 at 1000pfs).
Playback Mode: Plays back in either direction at the selected rate when you press
the Play buttons.
Playback Rates: Single Step, 1, 2, 3, 4, 5, 10, (25 PAL, 30 NTSC), (50 PAL, 60
NTSC), 125, 250, 500, and 1000 frames per second, forward or
reverse.
Status Display: Record Rate, Shutter, Trigger Point, Trig (trigger actuated),
Event #, Frame #, Time of Frame (ms).
External Connections
Digital In: BNC connector PCB mount, software selectable for Phase Lock
In or Event Marker Input. Normally set to OFF.
Phase Lock In: TTL rising edge from 0 to 3.3 volts. PHASE LOCK IN is pulled to
+3.3 volts with an internal 10K ohm resistor. Designate each
unit as a master or slave.
Event Marker Input: One TTL input through a BNC connector on the Camera cable.
Input normally at +3.3 volts (white marker) falling to 0 volts by a
contact closure (black marker).
Digital Out: BNC connector PCB mount, software selectable for Phase Lock
Out or Strobe Out.
Phase Lock Out: TTL rising edge from 0 to 3.3 volts.
Strobe Output: TTL pulse normally low, goes high during exposure.
Video Output: BNC connector to VCR's and external monitors. RS-170 NTSC
or PAL, software selectable.