User`s manual

MegaPlus ES 1020 User’s Manual
Redlake MASD, Inc. Page 7 91000134-001 Rev. A
Hardware Setup
Connect Camera Link Cable
1. Connect one end of the Camera Link cable to the ES 1020, and the other
end to the Frame Grabber board installed in the PC.
Connect Power Cable
1. First, connect the Power Cable (male end) to the Power Adapter.
2. Connect the Power Cable to the camera’s Power connector. Connect
the power adapter to a standard wall outlet using one of the power
cables provided.
NOTE: Line up the “red dots” (  ) to ensure proper alignment of the cable
and connector.
Connect Optional Strobe/Trigger/Power Cable
1. First, connect the Power Cable (male end) to the LEMO connector on the Power Adapter.
2. Then, connect to the female end of the Power Cable to the camera’s Power connector.
3. Finally, connect the power adapter to a standard wall outlet using one of the power cables provided.
4. When the camera is receiving power, the
G
G
R
R
E
E
E
E
N
N Power LED will be on. When the
Y
Y
E
E
L
L
L
L
O
O
W
W Activity LED is
blinking, it indicates the micro processor is ready to receive a command.
NOTE: The camera is
designed with mounting
holes on all four outside
planes of the camera body,
for attaching the mounting
bracket. To ensure proper
camera orientation when
attaching the mounting
bracket, pay special
attention to the small arrow
and the word “up” located
on the serial number plate
on the rear of the camera.