User`s manual

MegaPlus
®
Model ES 1.0
2. CONTROLS AND CONNECTORS
2.1 Camera
NOTE: A lens cap is installed on each camera to keep dust from getting on the optical sensor or
components when it is shipped. Remove the lens cap and install your lens in a dust free
environment.
2.1.1 Mounting the Camera
The MegaPlus camera has a ¼-20 threaded screw hole for mounting purposes on the bottom of
the camera body (see Figure 2-1). There is a second hole, 0.228 inches in diameter, to
accommodate a locating pin. The tethered head mounting holes, two on each of the four sides,
are also shown in Figure 2-1.
Figure 2-1. Camera Body Bottom and Tethered Head Mounting Holes
2.1.2 Attaching the Lens
The camera uses a C-mount lens. Screw the lens clockwise into the lens mount until you are no
longer able to turn the lens with light pressure.
91000064-004 Revision A 2-1 USER’S MANUAL