User`s manual

MegaPlus
®
Model ES 1.0
Figure 3-2. Wedge Display
3.4.21 Display Wedge
The wedge command displays linearly increasing gray scales in each quadrant of the image as
shown in Figure 3-2. This function is useful for aligning the camera image to a frame grabber.
The display wedge defaults to OFF when the power to the camera is turned off.
TYPE IN: RESPONSE EXPLANATION
WDG ON
CR-LF Means the wedge is being displayed.
WDG OF
CR-LF Means the camera is imaging.
WDG?
Queries the state of the wedge display.
3.5 Query Commands
3.5.1 Status Query
The status query command enables the user to get all of the camera’s operating parameter
information with a single command.
TYPE IN: RESPONSE EXPLANATION
STS?
Gives complete camera status with one query.
Each parameter listed below is followed by a
carriage return.
RESPONSE DEFINITION EXAMPLE
DEF xx Shows defect conceal status. DEF ON
GAB xxxx Shows the gain balance setting. GAB 36
BKB xxxx Shows the black level balance setting. BKB –17
BKE xxxx Shows black level setting. BKE 58
MDE xx Shows the operating mode. MDE CS
EXE xx Shows the exposure time. EXE 58
STP x Shows the polarity of the strobe pulse. STP N
TRM x Shows the trigger logic polarity. TRM P
TRS xxx Shows the trigger source setting. TRS AIA
TRE x Shows the exposure state. TRE 1
RDM x Shows the readout mode. RDM 2
TPD xxx Shows the transfer pulse delay. TPD 150
TPW x Shows the transfer pulse width. TPW 5
DGN x Shows the digital gain setting. DGN 1
91000064-004 Revision A 3-11 USER’S MANUAL