User`s manual

MegaPlus
®
Model ES 4.0/E
3.5 Query Commands
3.5.1 Temperature Query
This command queries the temperature sensor on the Processor Board.
TYPE IN: RESPONSE EXPLANATION
TMP?
Queries the temperature sensor on the Processor
Board. Response is in degrees C.
xxC Indicates the camera temperature is as indicated.
3.5.2 Status Query
The status query command enables the user to get all of the camera’s operating parameter
information with a single command.
TYPE IN: RESPONSE EXPLANATION
STS?
Gives complete camera status with one query. The
list below shows a typical camera response to this
query. Your camera’s response may differ,
depending upon the password table loaded into
your camera.
RESPONSE DEFINITION EXAMPLE
BNS x Shows binning mode. BNS 1
DEF xx Shows defect concealment state. DEF ON
DGN x Shows the digital gain setting. DGN 1
EXE xx Shows the exposure time. EXE 58
FRS xx Shows the frame rate setting. FRS 15
MDE xx Shows the operating mode. MDE CS
OGC xx Shows the offset and gain state. OGC ON
RDM x Shows the readout mode. RDM 2
SMC xx Shows the smear correction status. SMC OF
STP x Shows the strobe pulse polarity. STP N
TPD xxxx Shows the transfer pulse delay. TPD 150.0
TPW xx Shows the transfer pulse width. TPW 12
TRM x Shows the trigger logic polarity. (May use TRP.) TRM P
TRS xxx Shows the trigger source setting. TRS AIA
3.5.3 Identification Query
This command queries the camera for its model number.
TYPE IN: RESPONSE EXPLANATION
IDN?
MEGAPLUS Camera,
Model ES 4.0/E
91000116-001 Revision B 3-11 USER’S MANUAL