How-To Guide

To ensure proper use of the sensors, it is essential to calibrate them regularly or when you
feel that the accuracy of the sensors is less good. Calibration helps the sensor to be located
in space.
In order to calibrate the sensors, slide 1 sensor on each drumstick (see 4 for mounting
instructions).
In the sensor pairing screen, on each line of the connected sensors, slide your finger to the
left to access the "calibrate" option.
Several sensor manipulations are expected:
The first consists in placing the drumstick equipped with the sensor to be calibrated
on a table and leaving it completely immobile for a few seconds. An animation will
show you the validation of the calibration.
This step allows the sensor to position itself in space.
The second step consists in rotating the sensor on itself on the vertical and horizontal
axes so that the sensor can visualize all the axes of the room.
A message will then be displayed to let you know that the calibration has been
completed.
This calibration step will allow your sensors to resist shocks without losing their
configuration.
Repeat this operation for all sensors.
For foot sensors, we recommend that you replace the drumstick sensors with the drumsticks,
then after calibration reposition them.
4 - Installation of the sensors
Slide the sensors associated with the hands onto the drumsticks. To do this, hold the
sensor tightly between your fingers and slide the drumstick from the olive into the
sensor while rotating it on itself .
Then slide the sensors associated with the feet into the straps provided for this
purpose.
Attach the strap to your foot, with the sensor upwards.
5 - Drumkit configuration
5.1 Configuring the elements with the drumsticks
Press on configure.
Select an item from the drum kit, then press configure to start configuring the
sensors.
Follow the instructions on the screen :
Hit once slowly with your left drumstick in the center of the chosen area.
Hit once slowly with your right drumstick in the center of the chosen area.