Installation Guide

RDQCI5214 Rev. 0 Page 7 Cered 06/01/2016
RDQCI5214 Rev. 0
Page 6 of 8 Certified 06/20/16
5 Inside the shower enclosure, using the pencil
marks on the wall jambs from the previous step, drill
two 1/8” holes through the strike jamb [H] and into
the wall jamb [D] 3/8” to 3/4” from the wall and
approximately 1” down from the top and up from
the bottom of the strike jamb. Drill a third hole
centered between the first two.
Remove the strike jamb and enlarge the three holes in
the strike jamb only to allow clearance for the screws.
Attach the strike jamb permanently with three #6 x 3/8”
pan head screws [G].
6 Slide the Hinge Jamb of the door panel
assembly [B] over the mounted wall jambso the
door will open outward. Adjust the door panel
assembly so there is a 1/4” clearance between
the strike jamb and the strike edge of the glass
door with it being in the closed position.
Mark the location of the hinge jamb on the wall
jamb with a pencil.
7 Inside the shower enclosure, using the pencil
marks on the wall jambs from the previous step, drill
two 1/8” holes through the hinge jamb of the door
panel assembly and into the wall jamb 3/8” to 3/4”
from the wall and approximately 1” down from the
top and up from the bottom of the hinge jamb.
Drill a third hole centered between the first two.
Remove the door panel assembly and enlarge the three
holes in the hinge jamb only to allow clearance for the
screws.
Attach the door panel assembly permanently with three
#6 x 3/8” pan head screws.
STRIKE
JAMB
CURB
WALL
JAMB
#6 X 3/8”
SCREW
”4/3 - ”8/3
HINGE
JAMB
DOOR PANEL
ASSEMBLY
#6 X 3/8”
SCREW
WALL
JAMB
”4/3 - ”8/3
1/4”
DOOR PANEL
ASSEMBLY
WALL
JAMB
STRIKE
JAMB
HINGE
JAMB
CURB
VINYL
SLEEVE
EXTERIOR