Installation Guide
RDQCI5214 Rev. 0 Page 8 Cered 06/01/2016
RDQCI5214 Rev. 0 Page 7 of 8 Certified 06/20/16
8 Slide the door handle [I] onto the strike
side of the door panel. Close the door and slide
the handle up and down until the magnet and strike
plate are aligned. Use a pencil and/or masking tape
to mark the location of the handle on the door.
Place the vinyl material [J] over the strike edge of
the door and carefully drive the handle onto the
door panel using a rubber or plastic mallet.
Close the door and check for proper operation of
the handle and magnet. (If adjustment is needed,
use a rubber or plastic mallet and a wood block
and lightly tap into place). Trim the excess vinyl
off with a utility knife.
NOTE: NEVER hit the door latch with a
metal hammer!!
9 NOTE: The clear bottom sweep [C] is
notched on both ends. For installation, determine
if the door is hinge right or hinge left.
10 Align the clear bottom sweep to the
bottom of the door with the deflector lip on the
inside of the shower door. Mark the strike side
of the bottom sweep even with the strike edge
of the door. Cut the sweep leaving the notched
part under the metal rail.
HANDLE
VINYL
HANDLE
DOOR
PANEL
MAGNET
STRIKE
JAMB
WALL
JAMB
EXTERIOR
INTERIOR