Installation Guide

RDQCI5023 Rev. 0 Page 8 Cered 06/01/2016
BASCO
TOWEL BAR
ASSEMBLY
FINGER
PULL
7/8” TRUSS
HEAD SCREW
1 1/8” FLAT
HEAD SCREW
DECAL
TUB
TRACK
GLAZED
PANELS
CENTER
GUIDE
INTERIOR
#6 X 3/8 “ PAN
HEAD SCREW
BUMPER
WALL
JAMB
SCREW &
SPACER
INSERT
WALL SIDE
OF PANEL
10 From the exterior, insert a #10-24 x 7/8”
truss head screw [N] through the rail that is closest
to the center of the opening of the interior panel.
Then, insert a #10-24 x 1 1/8” flat head screw [P]
through an acrylic finger pull [R] and then through
the rail that is closest to the wall. Attach a towel bar
assembly, with the open slot in the bar facing down,
to the interior panel by threading the screws into the
acrylic brackets. (CAREFUL as to not overtighten
the screws and strip the acrylic). Peel the backing
from a TILE REDI decal [S] and press it into the
recess of the acrylic finger pull.
Repeat the above steps, but from the interior, for the exterior panel.
11 Locate the nylon bottom guide [T] in the
middle of the bottom track with both door panels
against the wall with the shower head. Using a 1/8”
drill bit, drill a hole into the “V” groove of the bottom
track through the hole in the nylon guide.
Install the guide using a #6 x 3/8” pan head screw [U].
12 Align the slots in the soft jamb bumpers [W]
with the outer rails of the door panels (the side rails
with the acrylic finger pulls). Slide the stainless steel
bumper inserts [V] into the soft jamb bumpers with the
open slot facing downward.
Slide the bumpers downward over the center wall jamb
screw until they “lock” onto the nylon spacers installed
in Step #4.
RDQCI5023 REV. 0
Page 7
Certified 06/22/2016