Installation Guide
RDQCI5285 Rev. 0 Page 8 Cered 06/01/2016
RDQCI5285 Rev 0 Page 8 Cered 06/17/2016
Drill one 3/16” diameter hole at the mark just made. Drill
through tile and backer board. Do not drill through block-
ing.
Note: This must be done just before Wall Mount Clamp
installation.
Disassemble the Wall Mount Clamp, and place the cover
plate and screw aside. Place the Wall Mount on the wall,
with the finished side of the clamp plate toward the inside
of the shower, and secure it to the wall with a #8 x 1-1/2”
truss head screw.
Note: Do not over tighten screw.
Using suction cups, set the Fixed Panel Glass back
into position. Double check exposed edges of the
glass are level and plumb.
Exposed edges MUST be level and plumb before
moving to next step.
Place the clamp cover plate on the outside of the glass
and secure from the inside w/ the screw provided.
COVER PLATE
INSIDE
SCREW
INSIDE
GASKET—BOTH SIDES OF GLASS