Installation Guide
RDQCI5284 Rev. 0 Page 6 Cered 06/01/2016
RDQCI5284 Rev 0 Page 6 Cered 06/17/2016
Using alcohol pads, wipe down the hinge notches
and notch gasket areas on the Door Panel Glass.
Allow glass to dry before continuing.
Remove the back plates from both Wall Mount Hing-
es. Place a gasket on the Hinge and place the fixed
part of hinge onto the Fixed Panel Glass.
Note: The Hinge with the logo must be the top Hinge.
Next, place another gasket against the glass and at-
tach the back plate with the screw provided. Interior
of hinges must press firmly against top side of notch.
Repeat on both Fixed Panel Glass notches and open
the hinges outward.
NOTE: Your hinges may differ in external shape
than what’s shown. However, installation proce-
dures are the same.