Installation Guide
RDQCI5284 Rev. 0 Page 8 Cered 06/01/2016
RDQCI5284 Rev 0 Page 8 Cered 06/17/2016
Place the Drip Vinyl onto the bottom of the door panel.
Line it up on the hinge side of the door and cut it off
flush with the strike edge of the door.
NOTE: The sweep may be pulled up or
down on the glass to adjust how much of
the sweep contacts the threshold
TIP: Run a small bead of silicone between
the drip vinyl and the glass to secure the
vinyl sweep and prevent water from col-
lecting inside the sweep if adjusted.
NOTE: DO NOT USE the shower until the
silicone is completely cured. Check the
tube of silicone for the manufacturer rec-
ommended cure time (typically 24 - 48
hours).
To prevent the door from sagging after final gap
adjustment the hinge maybe shimmed to prevent
movement.
Remove one back plate at a time and fill gaps
(marked in the figure to the left) surrounding
hinge with shims supplied in parts pack. Make
sure to shim both hinges and use combination of
shim thicknesses to fill entire gap.