Instructions / Assembly
Table Of Contents
- Safety
- Specifications
- Qualified Installing Agency
- Product Features
- Local Codes
- Preparing For Installation
- Unpacking
- Water Vapor: A By-Product Of Unvented Room Heaters
- Air For Combustion and Ventilation
- Installation
- Operation
- Inspecting Heater
- Care And Maintenance
- Troubleshooting
- Replacement Parts
- Accessories
- Service Hints
- Technical Service
- Parts
- Warranty
- 200041-01B Spn.pdf
- Seguridad
- Especificaciones
- Agencia de Instalación Calificada
- Características del Producto
- Normas Locales
- Preparación Para la Instalación
- Desempaque
- Vapor De Agua: Un Producto Derivado de Los Calentadores de Habitación Sin Ventilación
- Aire para combustión y ventilación
- Instalación
- Funcionamiento
- Inspección del calentador
- Cuidado y mantenimiento
- Solución de problemas
- Piezas de repuesto
- Accesorios
- Consejos para servicio
- Servicio técnico
- Piezas
- Garantía
www.sureheat.com
13200041-01B
3. Insert wall anchor (wings rst) into hole.
Tap anchor ush to wall.
4. For thin walls (1/2" or less), insert red
key into wall anchor. Push red key to
“pop” open anchor wings (see Figure
11, page 12).
IMPORTANT: Do not hammer anchor key! For
thick walls (over 1/2" thick) or solid walls, do
not pop open wings.
5. Place mounting bracket onto wall. Line up
last hole on each end of bracket with wall
anchors.
6. Insert mounting screws through bracket
and into wall anchors.
7. Tighten screws until mounting bracket is
rmly fastened to wall.
Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back panel
of heater (see Figure 12).
2. Place heater onto mounting bracket. Slide
horizontal slots onto stand-out tabs on
mounting bracket.
Installing Bottom Mounting Bracket
1. Install bottom bracket to heater bottom
with two screws. It may be more conve-
nient to remove heater from wall bracket
to attach.
2. Place heater on wall mounting bracket.
3. Mark screw locations on wall.
INSTALLATION
Figure 12 - Mounting Heater Onto
Mounting Bracket
Mounting
Bracket
(attached
to wall)
Horizontal Slots
Stand-Out Tab
Figure 13 - Installing Bottom Mounting Screws
Wall
Spacer
Heater
Side View
Front View
10,000 Btu
Front View
20,000 Btu or 30,000 Btu
4. Remove heater from mounting bracket.
5. If installing bottom mounting screws into hol-
low or solid wall, install wall anchors. Follow
steps 1 through 4 under Attaching To Wall
Anchor Method, page 12. If installing bottom
mounting screw into wall stud, drill holes at
marked locations using 9/64" drill bit.
6. Replace heater onto mounting bracket.
7. Place spacers between bottom mounting
holes and wall anchor or drilled hole.
8. Hold spacer in place with one hand. With
other hand, insert mounting screw though
bottom mounting hole and spacer. Place
tip of screw in opening of wall anchor or
drilled hole.
9. Tighten both screws until heater is rmly
secured to wall. Do not over tighten.
Note: Do not replace front panel at this time.
Replace front panel after making gas connec-
tions and checking for leaks.