Instructions / Assembly

functions will stop even though the switches may be in the I position.
CAUTION:
If you use this heater in conjunction with a thermal control, a program controller, a
timer or any other device that switches on the heater automatically, remember to
observe all safety warningS at all times.
The stove heater has safety overheat protection. If the overheat protection trips,
turn off the Power Switch and unplug the power cord from the receptacle. It will
reset automatically after 5 minutes.
FLAME EFFECT
The flame effect is created with the use of a 40 watt B-10 candelabra light bulb with
an E-12 (small) socket base. The light bulb will have to be replaced from time to
time when it burns out.
During normal operation, the stove heater will always give you simulated flame
function. If the intensity of flame suddenly increases, it means that the light bulb is
going to burn out.
Replace the light bulb immediately, according to the instructions below. Do not
operate the stove heater when the light bulb burns out or without the light bulb.
Doing so will void the warranty.