Instructions / Assembly

POWER: Press this button into the I position for main power and flame effect. The
indicator light will turn on. See below for other control switches.
LOW HEAT: For low infrared heat function (1000 Watts), press this switch while the
Power switch is in the I position for low heat. The indicator light will turn on.
HIGH HEAT: For high infrared heat function (1500 Watts), press this switch while
the power and Low switches are in the I position for high heat. The indicator light
will turn on.
THERMOSTAT: To adjust the temperature to your individual requirements,turn the
thermostat dial to the right (clockwise) to increase the desired temperature and to
the left for lower temperature. This thermostat control dial can only be used while
the POWER switch and HEAT switches are in the I position.When the heater reaches
the desired temperature, the heater and HEAT indicator light will turn OFF but the
fan will continue to operate. Turning this knob (THERMOSTAT) to to the right will
increase desired temperature and restart the heater.
IMPORTANT: The heat output is controlled by the thermostat, according to the
room temperature. Set the thermostat dial fully clockwise to the maximum position
initially.
When the room is warm enough, reduce the setting by slowly turning the thermo-
stat dial counter-clockwise until the heater “clicks.” This will then maintain the
room temperature at the desired level.
FLAME INTENSITY: Turn the dimmer dial clockwise or counter clockwise to get the
desired flame intensity. The dimmer switch can only be used when the POWER
switch is in the I position.
NOTE: When the POWER switch is turned to the OFF position, all other heater