RER11289 Redcat Portal Axle Kit Instructions

Redcat Racing

Now is a good time to change the chassis mounting position of the upper links. Currently, they are mounted in the low/forward

position. We recommend starting with the upper/middle position.

Here is where the links are most likely mounted:

Here is where the links need to be mounted for the

portal axles instillation:

Now, you can go ahead and install the rear portal axle.

Start by connecting the drive shaft coupler to the input shaft

on the portal axle by using the screw pin you removed from

the original axle. Now, mount the upper links to the portal

axle housing using the 3x28mm BH Screw and an M3 Lock

Nut and the lower links (using the upper holes in the link

mounts using the 3x16mm BH Screws and M3 Lock Nuts.

When finished, here’s what you should see:

Now is a good time to install the shocks onto the front

and rear axles. Feed the shocks through the holes in the

fenders down to the axles, and pop the shock rod ends

onto the installed ball studs.

These are located here:

13)

14)

15)

Redcat Racing

Installation Instructions

Redcat Racing

Portal Axle Upgrade Kit Installation Instructions