User Manual

Thank you for your purchase of a new Hexfly steering servo
In order to achieve proper performance, please follow the below steps:
1) Ensure you plug the servo into your receiver with the correct polarity. This will be different on
each receiver, check your receiver owners manual if you are unsure.
2) When first setting up your servo, turn the car and radio on with the servo plugged in. Make sure
to center all steering trim and then install the servo horn at a 90 degree angle to the servo.
3) Make sure if your radio has EPA (end point adjustment) settings, that you set these properly. To
do so, turn your EPA to the highest setting that makes your wheel turn to full steering lock, but
not further. Adjusting it past this point can damage the servo.