Instruction Manual
4-16Ω/
100V
OUTPUT
4-16Ω
100V
COM
BATT SUPPLY
DC24V
8A
4-16Ω/
100V
OUTPUT
4-16Ω
100V
COM
BATT SUPPLY
DC24V
8A
8
5. OPERATION ILLUSTRATION
1. Connect the speakers:
Minimum speaker impedance: 4 Ω
SPK-
SPK+
① When the 100V and 4 -16Ω selector switch to
4-16Ω position, as shown below:
②W hen the 100V and 4 -16Ω selector switch to
100V position, as shown below:
Maximum output voltage: 100V
Note:
1. Before connecting the speakers, please make sure that the equipment is powered off. In the
case of power on, may have the risk of electric shock.
2. Pleasemake sure thereare noapplied load to the speaker cables
3. During the installation of speakers, please make sure that the sum of the rated input power
of the speakers to be connected is less than rated power of equipment.
2.Connect external devices
Please ensure that the equipment and all equipment will be connected are powered off.
Using the corresponding cable to connect this equipment and other external equipment.
:
3.Connect the power line and turn it on:
Please make sure that thepowerswitchofequipment and itsconnected equipment are
turned off (in the OFF position).
Turn the volume knob to the left
Connect the supplied power line to the AC IN interface
Plug the power line intotheapplicablesocket
Turn on the connected equipment (CD playeretc), and then turn on the equipment
Note:
1Before powering on, please check and make sure there is no problem with the cable and connection.
2When you turn off the system, turn off the equipment, and then turn off the connected equipment.
SPK-
SPK+