User Manual

Using the drilling template provided, drill the

mounting hole(s) and then t the Remote Head to

the gear surround trim from behind, securing with

the nut provided.

To correctly align knob, rotate the sha fully an-

ti-clockwise and t the knob with ‘0’ at the TOP.

Tidy up any excess Remote Head cable, connect to

the Remote Head when retting trim.

Connect small ‘Signal Conditioning Module’ (1)

supplied in kit, to the small 2-way connector near

the 4-way Power MOLEX, ensuring you hear the

‘click’ of engagement, and secure to wiring with two

cable ties (2).

Secure all parts and wiring and ensure clear of sharp

edges and moving parts.

Re-t all trim.

FIDoc# - TPWKIT-012-FI 3Page of 5 Issue# - 4 Date - 04/09/2019

TPWKIT-012

Electric Trailer Brake Controller Kit tting instructions, suitable for:

Ford Ranger / Everest

Route the Remote Head cable (1) along existing

wiring (forward of glovebox hinge) to the area to the

Right Hand Side of the Gear shi.

Under the vehicle, route the TWIN CORE BLUE/

RED cable (1) along the chassis rail rearwards, secur-

ing to existing vehicle wiring where possible. If no

wiring near, feed cable ties through chassis holes and

secure wiring to side face, as indicated le.

Route to the trailer socket.

Ensure the wiring is clear of any hot surfaces; mov-

ing parts and sharp edges. Do not secure to fuel or

brake lines.