User Manual

ManualsBrandsRedarc ManualsBrake Controller Wiring KitsTow Pro Wiring Kit to Suit Ford Ranger & Everest

In the Engine Compartment in front of the

passenger, pierce the end of the main grommet

nipple (1), and feed the terminal end of the fused

BLACK wire through to the interior.

Do not connect to Battery positive yet.

FIDoc# - TPWKIT-012-FI 1Page of 5 Issue# - 4 Date - 04/09/2019

TPWKIT-012

Electric Trailer Brake Controller Kit tting instructions, suitable for:

Ford Ranger / Everest

Remove Glovebox; Passenger side Scu Trim; Kick

Trim and B-Pillar Lower Trim

Remove both centre console lower Side Trims (1)

and then Lower Centre Console (2) (xings ex-

posed).

is allows for the Gearshi surround trim (3) to be

removed.

SINGLE CORE

BLACK +12V

FUSE

MAIN

UNIT

EARTH

WHITE

VEHICLE

GROMMET

VEHICLE

GROMMET

REMOTE

HEAD

TWIN CORE

RED/BLUE

TRAILER

CONNECTOR

Summary of content (5 pages)

PAGE 1
Electric Trailer Brake Controller Kit fitting instructions, suitable for: Ford Ranger / Everest TPWKIT-012 TRAILER CONNECTOR REMOTE HEAD VEHICLE GROMMET FUSE SINGLE CORE BLACK +12V MAIN UNIT VEHICLE GROMMET EARTH WHITE 01 TWIN CORE RED/BLUE Remove Glovebox; Passenger side Scuff Trim; Kick Trim and B-Pillar Lower Trim 02 2 1 Remove both centre console lower Side Trims (1) and then Lower Centre Console (2) (fixings exposed). 1 This allows for the Gearshift surround trim (3) to be removed.
PAGE 2
Electric Trailer Brake Controller Kit fitting instructions, suitable for: Ford Ranger / Everest TPWKIT-012 04 Locate the 40mm grommet (1) under the Passenger Front seat (under carpet) and discard. Feed the unterminated end of the TWIN CORE BLUE/RED cable (2) through from the inside, until you reach the new grommet. 1 Ensure the grommet is correctly fitted to provide a waterproof and dustproof seal.
PAGE 3
Electric Trailer Brake Controller Kit fitting instructions, suitable for: Ford Ranger / Everest TPWKIT-012 08 Route the Remote Head cable (1) along existing wiring (forward of glovebox hinge) to the area to the Right Hand Side of the Gear shift. 1 09 Using the drilling template provided, drill the mounting hole(s) and then fit the Remote Head to the gear surround trim from behind, securing with the nut provided.
PAGE 4
Electric Trailer Brake Controller Kit fitting instructions, suitable for: Ford Ranger / Everest TPWKIT-012 12 Open the trailer socket (7-pin shown as example); remove any cable clamp and peel back boot (if fitted). 4 7 2 2 Feed RED of TWIN CORE (2) under boot, and combine with existing RED (1) in terminal 6 position and re-tighten. 3 5 6 1 1 13 2 1 If any BLUE is fitted to terminal 5 position, remove and insulate, pulling back to main harness.
PAGE 5
Electric Trailer Brake Controller Kit fitting instructions, suitable for: Ford Ranger / Everest TPWKIT-012 Template - Confirm the scale is correct before use. 50mm 50mm Everest Ranger Ø3.5mm* Ø3.5mm* Ø10mm Ø10mm * The 3.