User Manual

Suitable for: Amarok Utility
FI13205
Issue: 4 Date: 14/08/2018
Kit Part No: TPWKIT-010
© 2018
14
1
2
Step 9
• Secure the Electric Brake Harness fused ring terminal to the
vehicle positive terminal using the existing fastener.
(1)
(2)
Step 8
Step 7
2
3
1
2
• Remove the vehicle grommet located underneath the
passenger side footwell carpet.
• Route the loose terminals of Electric Brake Harness over the
chassis near the LHS wheel liner and through the grommet hole
into the vehicle cabin, and up to the LHS kick panel.
(1)
(2)
Important
Important: Ensure the Electric Brake Harness grommet is
seated correctly and makes a good seal.
(3)
2
1
• Route harness (1) up past the kick panel into the LHS dash cavity.
Use the supplied edge clip cable tie (2) to secure to vehicle
sheet metal.
Important
Important: Ensure harness is secured away from any sharp
metal edges that could rub against and damage the wiring.
Page 07 of