User Manual

Suitable for: Amarok Utility
FI13205
Issue: 4 Date: 14/08/2018
Kit Part No: TPWKIT-010
© 2018
Step 16
Page 10 of
Step 17
Step 18
• Remove the knee trim (1) and use the supplied Template (2) to
drill the hole for the switch fascia.
2
1
7
67
1
• Fit the switch fascia (4) into the hole in the knee trim (1).
•
•
•
• Secure the CAT 5 cable to the existing vehicle wiring harness
with cable ties and refit the knee trim (1)
Plug the CAT 5 Cable , into the remote head and fit the
remote head to the switch fascia from behind.
Secure the remote head to the switch fascia by fitting the nut
(5) from the front. Torque the nut to 0.8 Nm.
Rotate the shaft fully anti-clockwise and fit the knob to
the shaft with “0" pointing upwards as shown below.
.
(2) (3)
(4)
(6) (7)
(6)
7
6
5
7
6
3
2
4
1
• From underneath the vehicle, route the Electric Brake Harness
down the LHS chassis rail following the existing vehicle harness
towards the trailer socket at the rear of vehicle.
• Secure Electric Brake Harness to the existing vehicle harness at
every 300mm using supplied Cable Ties.
(1)
Important
A guide wire may be required to continue routing the Electric
Brake Harness near the LHS rear wheel area.
14