User Manual

Suitable for: MITSUBISHI PAJERO

FI12045

Issue: 2 Date: 24/05/2018

Kit Part No: TPWKIT-009

• Locate to the 4-way connector at the rear of the LHS head light.

• Disconnect and discard the blanking plug from the 4-way

connector.

• Install the Engine Bay Harness black wire terminal into position 3 of

the supplied connector then insert the supplied Plug Seals into the

remaining cavities.

• Connect the Engine Bay Harness (1) to the vehicle harness 4-way

connector (2).

Note: If the vehicle is fitted with a Trailer Wiring Harness, then use the

existing 4-way connector and house terminal in pin 3.

Page 15 of

Step 32

Step 31

Step 33

Rear view of Connector

• Install the positive terminal (1) to the positive battery terminal stud

(2).

• Secure the harness (3) with the supplied Cable Ties (4) in the

indicated locations.

• Re-connect the negative battery terminal.

• Test the operation of the Tow-Pro system as per the Tow-Pro user

manual.

E. & O.E. This document is copyright and must not be used except as permitted below or under the Copyright Act 1968. You may reproduce

and publish this document in whole or in part for your or your organisation's own personal or internal compliance, educational or non-

commercial purposes. You must not alter or amend this document in any way. You must not reproduce or publish this document for

commercial gain without the prior written consent of the copyright owner.

Secure all harnesses to the vehicle using cable ties.

Refit all removed parts and secure all fasteners to

the Service Manual torque specifications.

Important

Reprogram all radio stations and clock settings by

referring to the vehicle’s Owners Manual.

Important

Please place the Fitting Instructions and Owner’s

Manual in the glovebox after the installation is

completed.

Note: The colour of the wire on the

vehicle-side of the terminal must match

the wire colour on the vehicle-side of the

terminal used in steps 27 - 30.