User Manual

Suitable for: Nissan Navara NP300
FI11928
Issue: 3 Date: 14/08/2018
15
Kit Part No: TPWKIT-008
© 2018
Step 10
Step 11
Step 12
• Inside the drivers side lower trim, locate the two studs (1).
• Slide the two supplied M8 Large Flat Washers (2) over the upper
threaded stud.
Step 11
2
1
1
• Secure the Brake Controller ECU (1) to the ECU Bracket (2) using
the supplied M4 Screws (3), M4 Spring Washers (4) and M4 Flat
Washers (5).
• Fit the supplied Grommet (6) to the slotted hole of the ECU Bracket
(2).
2
1
Page 07 of
2
6
Cat 5
cable
4-way ECU
connector
3
4
5
4
3
5
4
5
• Fit the remote head (1) to the blank switch panel (2).
• Secure the remote head (1) to the blank switch panel (2) as
shown. Torque the nut (3) to 0.8 Nm.
• Rotate the shaft (4) full anti-clockwise and fit the knob (5) to the
shaft (4) with “0" pointing upwards as shown below.
• Refit the blanck switch panel (2) to the cupholder assembly (6).
1
2
6