User Manual

Step 27

Page 13 of

• Locate the ‘Blue’ wire that is taped back on the trailer wiring

harness near the 8-way connector.

• Locate the ‘Blue’ wire that is taped back on the Electric Brake

Harness.

• Cut the brass ferrule off and strip the insulation back 10mm on

both the ‘Blue’ wires.

• Slide the supplied Heatshrink over the wires before crimping

•

both

wires using the supplied Butt Splice with an indent type crimpers.

Solder the wires to the butt splice. Ensure that a good connection

is made.

• Wait for the butt splice to cool, slip heatshrink over the joint and

heat.

1 2

3 4

Keep heatshrink away from joint until after soldering is

complete and cooled.

Step 28

• Re-connect the negative battery terminal.

• Test the operation of the Tow-Pro system as per the Tow-Pro user

manual.

• Dispose of any parts not used from the fitment.

Important

Secure all harnesses to the vehicle using cable ties.

Refit all removed parts and secure all fasteners to the

Service Manual torque specifications.

Important

Reprogram all radio stations and clock settings by

referring to the vehicle's Owner's Manual.

Please place the

in the glov box after installation completed.

Fitting Instructions and Owner's

Manual e is

E. & O.E. This document is copyright and must not be used except as permitted below or under the Copyright Act 1968. You may reproduce

and publish this document in whole or in part for your or your organisation's own personal or internal compliance, educational or non-

commercial purposes. You must not alter or amend this document in any way. You must not reproduce or publish this document for

commercial gain without the prior written consent of the copyright owner.

Suitable for: Nissan Navara NP300

FI11928

Issue: 3 Date: 14/08/2018

Kit Part No: TPWKIT-008