User Manual

Suitable for: Nissan Navara NP300

FI11928

Issue: 3 Date: 14/08/2018

Kit Part No: TPWKIT-008

Step 21

Page 10 of

Step 19

Step 20

• Inside the vehicle, route the Electric Brake Harness (1) from the

passenger footwell to the driver’s side kick panel area.

• Secure the Electric Brake Harness (1) to the existing vehicle

harness using the supplied Cable Ties.

• Connect the 4-Way Connector (1) from the Electric Brake Harness

(2) to the Brake Controller ECU (3).

• Connect the Cat 5 Cable (4), supplied in the wiring kit, to the Brake

Controller ECU (3).

• Inside the vehicle, using the table below, house the terminals (1)

from the Electric Brake Harness into the supplied 4-Way

Connector (2), ensuring the terminals lock into the housing .

• Snap off the secondary lock (3) from behind the 4-Way

Connector (2).

• Fit the secondary lock (3) to the underside of the 4-Way

Connector (2).

Wire Colour

Terminal

Red

Blue

White

Black

Rear View of Connector

(Wire Entry Side)

4 3 2 1

Ensure the Electric Brake Harness (1) is routed in a way as to

avoid any sharp areas. Be sure to avoid contact with the

vehicle steering column and pedals.