User Manual

FI11979
Issue: 4 Date: 14/08/2018
© 2018
Kit Part No: TPWKIT-007
Suitable for: Kluger / Prado
Step 17
Step 16
Page 09 of
• Remove the switch blank (1) from the drivers under dash trim (2).
• Route the Cat 5 Cable (3) along the dash towards the under dash
trim (2) area. Secure using the supplied Cable Ties.
2
1
(Kluger)
• Insert the supplied Switch Insert (1) into the vacant cavity on the
drivers under dash trim (2).
• Insert the Electric Brake Switch (3) into the Switch Insert (1) from
behind.
• Fasten the supplied Nut (4) locking the Electric Brake Switch (3) to
the Switch Insert (1). Torque the Nut (4) to 0.8Nm.
• Rotate the shaft (5) fully anti-clockwise and fit the knob (6) to the
shaft with “0" pointing upwards as shown.
• Connect the Cat 5 Cable (7) to the Electric Brake Switch (3) from
behind.
• Secure the excess Cat 5 Cable (7) with the supplied Cable Ties.
• Reinstall the drivers under dash trim (2).
1
7
3
6
4
5
6
2
1
Important
Ensure the Cat 5 Cable (3) does not interfere with the steering
column, any of the vehicle pedals or the airbag system.
3
• In the engine bay, locate the three loose wires on the Electric
Brake Harness (1) and route down the firewall and towards the LHS
chassis rail.
• Secure to the existing vehicle harness using the supplied Cable
Ties.
Important
Ensure the Electric Brake Harness (1) does not make contact
with any sharp edges or moving parts. Avoid areas of extreme
temperatures.
Step 18
1
KLUGER
21