User Manual

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

Step 10

Step 11

Step 12

Page 07 of

• Clean off any lubricant used in previous step.

• Seal the grommet (1) around the Electric Brake Harness (2) using

silicone sealant, on the engine bay and cabin sides of the

grommet (1).

• Secure the Electric Brake Harness (2) to the vehicles main harness

using a supplied Cable Tie (3).

both

• Inside the vehicle, route the Electric Brake Harness (1) from the

grommet towards front passenger RHS footwell area.

• Secure the Electric Brake Harness (1) to the existing vehicle

harness using the supplied 200mm Cable Ties (2) as shown.

Important

Ensure the Electric Brake Harness is kept away from

any sharp or moving parts and clear of being pinched

by trim re-fitment.

• Using the table below, house the terminals (1) from the Electric

Brake Harness into the supplied 4-Way Connector (2) ensuring the

terminals lock into the housing.

• Snap off the secondary lock (3) from behind the 4-Way

Connector (2).

• Fit the secondary lock (3) to the underside of the 4-Way

Connector (2).

Wire Colour

Terminal

Red

Blue

White

Black

Rear View of Connector

(Wire Entry Side)

4 3 2 1

KLUGER