User Manual

Step 7

Step 9

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

Step 8

Page 06 of

• Remove the two fasteners (1) from the driver’s garnish underside

trim (2).

• Press down on the clip (3) and remove driver’s garnish underside

trim (2).

• Remove the one lower trim fastener (4).

• Dislodge the driver’s garnish lower trim (5).

• Disconnect all switch connectors from behind the switch panel

and one connector (6) next to the boot latch .

• Disconnect the boot latch (7).

• Remove the driver’s garnish lower trim (5).

SRS

AIRBAG

• In the front passenger side foot well, locate the upper grommet

nipple (1) on the firewall grommet.

• Carefully cut off the grommet nipple (1) using a sharp knife.

• ecure the section of the Electric Brake Harness

(1) with the four terminals to a guide wire (2) using tape. Keep the

thickness of the taped section small.

• On the LHS firewall grommet (3), lubricate the upper grommet

access point (4) with a suitable lubrication if required. Feed the

guide wire (2) into the upper grommet access point (4).

• Ensure the guide wire (2) breaks the internal seal and continue

feeding the harness into the cabin until the corrugated section of

the harness contacts the grommet (3).

In the engine bay, s

KLUGER