User Manual

Parts Supplied

Safety Notes

General Notes

Tools Required

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

•

Read through the fitting instructions before installation of the accessory. Install the accessory following the fitting

instructions. Failure to do so may cause damage to the vehicle or the accessory.

Ensure all recyclables, discarded vehicle accessory components and packaging are recycled following local recycling

regulations.

It is always recommended that this accessory is fitted by a qualified automotive Technician.

Safely store and protect any removed vehicle components.

Ensure all bare metal surfaces are protected using automotive bare metal primer and touch-up paint, or suitable

automotive rust inhibitor.

Remove all metals swarf and dust from all vehicle surfaces if surfaces is used for accessory installation.

•

Check that all work practices comply with safety standards.

Please wear appropriate clothing and use safety equipment.

Ratchet Socket Set Guide wire

Phillips Head Screw Driver

Trim Removal Tools

PVC Tape

M4 Pan Head Screws x4

M4 Flat Washer x4

Electric Brake Harness x1

Switch Insert x1

Cable Ties x40

200mm x20

900mm x20

M6 Flat Washer x1

M6x16 Bolt x1

Fitting Instruction x1

Ø6mm Heatshrink x1

Silicone Spray Silicone Sealant

Page 02 of

2.5m Cat 5 Cable x1

4-way Connector x1

Butt Splice x1

M4 Nyloc Nut x4

Brake Controller

Bracket x1