User Manual

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

• Route the Cat 5 Cable (1) towards the drivers under dash trim

area.

• Secure the Cat 5 Cable (1) to the existing vehicle harness using

the supplied 200mm Cable Ties.

Step 13

Step 14

Step 15

• Insert the supplied Switch Insert (1) into the vacant cavity on the

drivers under dash trim (2).

• Insert the Electric Brake Switch (3) into the Switch Insert (1) from

behind.

• Fasten the supplied Nut (4) locking the Electric Brake Switch (3) to

the Switch Insert (1). Torque the Nut (4) to 0.8Nm.

• Rotate the shaft (5) fully anti-clockwise and fit the knob (6) to the

shaft with “0" pointing upwards as shown.

• Connect the Cat 5 Cable (7) to the Electric Brake Switch (3) from

behind.

• Secure the excess Cat 5 Cable (7) with the supplied Cable Ties.

• Reinstall the drivers under dash trim (2).

• In the engine bay, locate the three loose wires on the Electric

Brake Harness (1) and route down the firewall and towards the LHS

chassis rail.

• Secure to the existing vehicle harness using the supplied Cable

Ties.

Important

Ensure the Electric Brake Harness (1) does not make contact

with any sharp edges or moving parts. Avoid areas of extreme

temperatures.

Page 17 of

PRADO