User Manual

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

Step 10

Step 11

Step 12

• Using the supplied M6 Bolt (1) and M6 Flat Washer (2), secure the

ECU Bracket assembly (3) to the inside panel on the LHS of the

glovebox area.

Important

Ensure the vehicle metal tab (4) is located in the slot of the ECU

Bracket.

• Connect the 4-way connector (1) from the Electric Brake Harness

to the Brake Controller ECU (2).

• Connect the Cat 5 Cable (3), supplied in the wiring kit, to the

Brake Controller ECU (2).

Page 16 of

PRADO

• Inside the vehicle, route the Electric Brake Harness (1) towards the

front passenger kick panel area.

• Secure the Electric Brake Harness (1) to the existing vehicle

harness using the supplied 200mm Cable Ties (2) as shown.

Important

Ensure the Electric Brake Harness is kept away from

any sharp or moving parts and clear of being pinched

by trim re-fitment.

Note: In some vehicles a spare connector or clip may be located

here. If so, unclip and secure back to existing wiring out of the

way before proceeding.

Important

If the area is being used by another ECU, remove the main unit

from its bracket and secure it with Cable Ties in this area.