User Manual

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

• Using the table below, house the terminals (1) from the Electric

Brake Harness into the supplied 4-Way Connector (2) ensuring the

terminals lock into the housing.

• Snap off the secondary lock (3) from behind the 4-Way

Connector (2).

• Fit the secondary lock (3) to the underside of the 4-Way

Connector (2).

Step 7

Step 9

Step 8

• Clean off any lubricant used in previous step.

• Seal the grommet (1) around the Electric Brake Harness (2) using

silicone sealant, on the engine bay and cabin sides of the

grommet (1).

• Secure the Electric Brake Harness (2) to the vehicles main harness

using a supplied Cable Tie (3).

both

Wire Colour

Terminal

Red

Blue

White

Black

Rear View of Connector

(Wire Entry Side)

4 3 2 1

Page 15 of

PRADO

• Secure the Brake Controller ECU (1) to the ECU Bracket (2) using

the supplied M4 Pan Head Screws (3), M4 Flat Washers (4) and M4

Nyloc Nuts (5).

Important

Ensure to use the mounting holes (6) on the ECU Bracket (2)

that are designed for the Toyota Prado.