User Manual

FI11979

Issue: 4 Date: 14/08/2018

Kit Part No: TPWKIT-007

Suitable for: Kluger / Prado

Step 4

Step 6

Step 5

•

• Dislodge the driver’s garnish lower trim (2).

• Remove the vehicle switch blank (3) by pushing from behind.

Remove the RHS dash side garnish (1).

• On the LHS side of the engine bay, locate the grommet nipple (1)

on the firewall grommet (2).

• Carefully cut off the grommet nipple (1) using a sharp knife.

• ecure the section of the Electric Brake Harness (1) with the four

terminals to a guide wire (2) using tape. Keep the thickness of the

taped section small.

• On the LHS firewall grommet (3), lubricate the upper grommet

access point (4) with a suitable lubrication if required. Feed the

guide wire (2) into the upper grommet access point (4).

• Ensure the guide wire (2) breaks the internal seal and continue

feeding the harness into the cabin until the corrugated section of

the harness contacts the grommet (3).

Page 14 of

PRADO